Exchange in 3 steps
-
Set the ETH amount and paste your Render payout address on SPL on Solana.
-
Create the order to lock the quote and see the deposit address.
-
Send ETH to that deposit. After confirmations, RENDER is paid to your wallet.
Before you broadcast
- Ethereum deposits confirm quickly — usually within a few blocks (~12s each).
- During gas spikes, confirmation cost rises but inclusion remains fast.
- Send ETH on Ethereum mainnet only — not BSC, Base, or other L2s unless your order says otherwise.
- RENDER not visible yet? Wait a few minutes, resync your wallet, then contact support with your order ID if the payout tx is already listed.
Ethereum — programmable money on-chain
ETH powers Ethereum mainnet — gas, staking, DeFi, and most smart-contract activity in crypto live here.
Sending ETH to the right network
Use an Ethereum mainnet wallet for deposits. L2 or alternate-chain sends may not be credited.
Leave enough ETH in your wallet to cover gas on top of the swap amount.
Render on Solana
Always match RENDER on SPL on Solana when you send or receive — wrong-network transfers may not be credited.
Receiving RENDER
Your wallet must be on SPL on Solana.
Allow a few minutes after the order shows sent before opening support.
Before you swap
Avoid wrong-network deposits and address format mistakes — read these guides first.
Coin swap hubs
More no-KYC swap pairs and guides for each asset.
Frequently asked questions
Is identity verification required to trade ETH for RENDER?
No. GetSwap is a NO-KYC & Privacy-First Crypto Exchange — no profile, no ID upload, and no funded account for Ethereum → Render.
How long is a ETH → RENDER order?
Typical completion is a few minutes. Ethereum mainnet and SPL on Solana confirmation times set the pace.
Do you custody ETH or RENDER?
No. You send ETH yourself and RENDER is paid to the address you enter — GetSwap does not keep a wallet balance for you.
What if I pick the wrong ETH network?
Match the network printed on the order (Ethereum mainnet). A mismatch can strand the deposit — check the swap safety notes first.